Search

Search our shop

Gyeon Q2 Trim 30ml (SiO2-based Durability 6 Months)

GQ-116021

Size: 30ml
In-stock: Inventory updated

Gyeon Q2 Trim 30ml

Q² Trim has a formula that allows it to be applied on different vehicle’s parts: on plastics with their own structure, on unpainted parts, on so-called piano black finishes, which are most problematic to maintain, and on tail- and headlight covers after having them renovated. That unique quality is unlikely to be found in other available products.

BOX CONTAINS: Q² TRIM / MANUAL / APPLICATOR / 4 SUEDE CLOTHS

LONG LASTING RESTORATION

It is quite common to observe fading or discoloration of automotive finishing materials under the influence of UV radiation as well as strong chemicals used in car washes.

Q² Trim preserves the long-lasting, supreme effect of colour saturation, which translates into ensuring a mat or satin finish of materials. Even after 12 months, the effect of colour saturation does not diminish, which often means exceeding the durability of traditional products. 

BEST PRACTICE AND PRO-TIPS FROM YVES HEYLEN

Q² Trim is not just a protective coating, but represents very strong restorative/colour enhancement qualities. TIP: On porous, non-painted surfaces you may apply the product without wiping off. Ensure a very even finish and just leave the product to dry and cure. It will retain it’s initial look for months! You may use a foam applicator on trim with porous structure for a even finish.

  • CONSUMPTION: 30ml / 5-10 cars
  • PH TOLERANCE: 2-11
  • CONTACT ANGLE: >80'
  • THICKNESS: 0,2 - 0,5qm
  • DURABILITY: >24 months

Directions:

Ensure your trim or plastic surfaces are clean, dry and free from contamination; so wash thoroughly and dry (use a brush on textured surfaces to clean properly). We suggest ultimate durability can be achieved with a good cleanse with Gyeon Prep to remove all traces of old wax, polish or oils.

Shake the Gyeon Trim well, take one of the applicator cloths on top of the applicator block and apply a small amount of Trim. Wipe over a section (about 10cm x 10cm) gently ensuring you pass over all the area at least twice to provide even thick coverage.

Wait for 2-5 minutes depending on heat/humidity the coating should be absorbed and dry, if not then wipe off completely with a good quality microfibre cloth.

Repeat for all other sections on your trim until revived and coated. We recommend not getting the coating wet for at least 6 hours to allow it to properly cure.

Always coat in cool conditions, not in direct sunlight.

YouTube Video Thumbnail

YouTube Video Thumbnail